Nuclear Technology and Radiation Protection 2010 Volume 25, Issue 2, Pages: 133-137
doi:10.2298/NTRP1002133S
Full text ( 525 KB)
Cited by


Non-destructive technique to verify clearance of pipes

Savidou Anastasia, Stamatelatos Ion E.

A semi-empirical, non-destructive technique to evaluate the activity of gamma ray emitters in contaminated pipes is discussed. The technique is based on in-situ measurements by a portable NaI gamma ray spectrometer. The efficiency of the detector for the pipe and detector configuration was evaluated by Monte Carlo calculations performed using the MCNP code. Gamma ray detector full-energy peak efficiency was predicted assuming a homogeneous activity distribution over the internal surface of the pipe for 344 keV, 614 keV, 662 keV, and 1332 keV photons, representing Eu-152, Ag-118m, Cs-137, and Co-60 contamination, respectively. The effect of inhomogeneity on the accuracy of the technique was also examined. The model was validated against experimental measurements performed using a Cs-137 volume calibration source representing a contaminated pipe and good agreement was found between the calculated and experimental results. The technique represents a sensitive and cost-effective technology for calibrating portable gamma ray spectrometry systems and can be applied in a range of radiation protection and waste management applications.

Keywords: research reactor, decommissioning, primary cooling system, clearance, MCNP code, key radionuclides, pipe

More data about this article available through SCIndeks